Real parts, real materials, real edges.
Filmed and photographed on our floor in Foshan. Every sample names the material, the thickness range and the machine it came off, so you can match it to your own work.
Blue marble, contour-cut pieces
Straight off the slats. No chipping on the veined edge, no secondary finishing.
Cut on the AC 5-Axis Waterjet →AC head cutting marble slab
The 0–60° AC head following a contour on a full slab.
Cut on the AC 5-Axis Waterjet →Sink cutout with milled drainer grooves
Waterjet cuts the opening, the 24,000 rpm spindle mills the grooves: one setup.
Cut on the AC 5-Axis + milling spindle →
Milling spindle on a sink opening
Second carriage on the same gantry; the slab never moves between operations.
Cut on the AC 5-Axis + milling spindle →Square frame cut from tile, lifted off
Inner square and frame both usable; the kerf is the only material lost.
Cut on the AC 5-Axis Waterjet →Decorative pattern in tile
Tight radii in a brittle material without cracking.
Cut on the AC 5-Axis Waterjet →
Carbon steel block, straight cut edge
Cut edge shown as it left the table; no heat-affected zone, no burr.
Cut on the AC 5-Axis Waterjet →
Carbon steel block, face
Same block; the finish is uniform through the full thickness.
Cut on the 3-Axis Waterjet →
3-axis head, 0.79 in (20 mm) plate
Vertical head, production plate work.
Cut on the 3-Axis Waterjet →Porcelain sink cutout, straight off the table
The frame and the cutout held up as they came off the slats: clean edges, no chipping.
Cut on the AC 5-Axis Waterjet →
Glass: sculpted parts and basin
From the Rich catalog sample set.
Cut on the V5-Axis Waterjet →
Aluminum: perforated and lattice panels
From the Rich catalog sample set.
Cut on the 3-Axis Waterjet →
Marble: oval basin cut-out
Oval basin opening cut in black marble, basin dropped in straight from the table.
Cut on the AC 5-Axis Waterjet →
Ceramic: patterned tile inlays
From the Rich catalog sample set.
Cut on the V5-Axis Waterjet →
Slab: sink cutout with radius corners
Rectangular sink opening, tight radii and no chipping at the corners.
Cut on the 5-Axis Bridge + Waterjet →Send us your part. We cut it and send it back.
A drawing or a photo and the material is enough. You get the cut sample and the cycle time, before you buy anything.